WATCO Concrex Acid Resistant – acid-resistant epoxy repair mortar
€212.33
Product information "WATCO Concrex Acid Resistant – acid-resistant epoxy repair mortar"
Concrex Acid Resistant is WATCO's epoxy repair mortar for floors where aggressive chemicals are used, decanted or stored. Ordinary cementitious mortar is quickly attacked again in such areas; according to the manufacturer this formula withstands even 95% sulphuric acid. Acid-damaged areas can therefore be repaired permanently instead of being patched every year.
The manufacturer states that strength and handling match Concrex Carbon Fibre: mix the two components, place and trowel. It cures granite-hard and non-dusting, can be feather-edged and takes load after about 6 hours. A primer is usually not needed for hole repairs. Suitable for concrete, metal, brick and masonry.
Typical applications
- Chemical stores, decanting and dosing areas
- Production and processing plants with acid exposure
- Acid-damaged concrete floors, ramps and steps
Features
- Resists 95% sulphuric acid (manufacturer data)
- Slip resistant R12 to DIN 51130 (manufacturer data)
- For heavy vehicle and foot traffic
- Can be feather-edged for seamless transitions
Technical data (manufacturer)
| Base | 2-pack epoxy with aggregate |
|---|---|
| Substrates | Concrete, metal, brick, masonry |
| Coverage | approx. 1.2 m² per 10 kg at 5 mm |
| Cure time | 6 hours at 20 °C |
| Pot life | approx. 60 minutes at 15 °C |
| Min. floor temperature | 10 °C |
| Max. service temperature | 60 °C |
| Use | Indoors and outdoors |
| Storage | at least 8 h at 15–25 °C before use; frost-free; 12 months unopened |
Sold in the UK as Concrex Acid Strength. Where acid exposure is low, Concrex Carbon Fibre is the faster alternative.
Hazard information under CLP (according to the manufacturer's safety data sheet)
Component: Resin
Signal word: Warning
Hazard statements: H315 Causes skin irritation. H317 May cause an allergic skin reaction. H319 Causes serious eye irritation. H412 Harmful to aquatic life with long lasting effects.
Precautionary statements: P280 Wear protective gloves. Wear eye protection or face protection. P501 Dispose of contents and container in accordance with all local, regional, national and international regulations.
Supplemental information: EUH205 Contains epoxy constituents. May produce an allergic reaction.
Component: Curing agent
Signal word: Danger
Hazard statements: H314 Causes severe skin burns and eye damage. H317 May cause an allergic skin reaction. H361 Suspected of damaging fertility or the unborn child. H372 Causes damage to organs through prolonged or repeated exposure. H411 Toxic to aquatic life with long lasting effects.
Precautionary statements: P201 Obtain special instructions before use. P280 Wear protective gloves, protective clothing and eye protection or face protection. P273 Avoid release to the environment. P260 Do not breathe vapour. P391 Collect spillage. P308+P313 IF exposed or concerned: Get medical advice/attention. P301+P310, P330, P331 IF SWALLOWED: Immediately call a POISON CENTER or doctor. Rinse mouth. Do NOT induce vomiting. P303+P361+P353, P310 IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water. Immediately call a POISON CENTER or doctor. P305+P351+P338, P310 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER or doctor. P405 Store locked up. P501 Dispose of contents and container in accordance with all local, regional, national and international regulations.
Supplemental information: EUH211 Warning! Hazardous respirable droplets may be formed when sprayed. Do not breathe spray or mist.
Wording of the H, P and EUH statements as per CLP Regulation (EC) No 1272/2008, Annexes III and IV; pictograms derived from the classification. The manufacturer's label and current safety data sheet are authoritative.
Note: The components may be classified as hazardous. We will send you the current safety data sheets with classification, labelling and H and P phrases on request before you order. Supplied to trade and industrial users only.
Downloads
Technical Details
| Operating Conditions: | Abrasion-resistant, Acid and alkali resistant, Chemical resistant, Durable, For indoor use, For outdoor areas, For production environments, For warehouse, Slip-resistant |
|---|---|
| Sectors/Industry: | Chemicals & Pharmaceuticals, Food & Beverages, Industry & Production, Logistics & Warehousing, Maintenance & Technical Services, Oil, Gas & Petrochemicals, Water, Wastewater & Waste Management |
Login
Stock & Custom Solutions
Standard range from stock plus made-to-order solutions to your specifications.
Personal Expert Consultation
Direct contact with our experts – we find the technical solution for your problem.
Brand Quality
Products from renowned manufacturers – certificates and declarations of conformity per product on request.
Delivery DE & Nordics
Reliable delivery to Germany, Denmark, Norway, Sweden and Finland – Austria and Switzerland on request.
Our Bestsellers
The best-selling products for professional users.
About Hansehandel
What we at HANSEHANDEL, our products and solutions stand for
Our
Mission
Our mission is to make industrial procurement for our partners in Germany and Northern Europe as efficient and reliable as possible. We deliver not just products, but engineering expertise and dependable, personal support.
Our
Vision
We aim to be the agile partner for MRO solutions for companies in Scandinavia and Germany – with technical know-how, deep market understanding and a clear focus on industrial safety.
Frequently Asked Questions
Contact Us
We look forward to your technical challenge.
